84×48 dot matrix LCD, can show 4 lines of characters
Use serial interface communicate with the master processor, the number of interface signal
line reduced greatly, only 8 signal lines including power and GND.
Support different types of MCU, such as for arduino, for AVR, for SPI, for MCS51 and so on.
Transfer rate up to 4Mbps, can full speed write display data without waiting time.
Can use the conductive glue to connect the module with the printed board, without cables. The metal hooks on the module can fix the module on the printed board, which is very easy to
install and replace.
LCD controller/driver chip has been bound to LCD chip, the volume of LCD is small
Low power supply,the working current in normal situation is lower than 200μA and has a power-down mode
2.CE———- chip selection
3.DC———- data/commands choice
4.DIN——— serial data line
5.CLK——— serial Clock Speed
7.LIGHT——- backlight control terminal
8.GND——— power negative
Nokia 5110 – 3V-5V
Module size: 45.2mm x 43.1mm
1 x LCD Module for Nokia 5110